How to Fix A Washer That Fills and Drains At The Same Time

Having a faulty appliance in your house can be a pain, especially if you have guests at home or throwing a party. Imagine, your microwave stops working when you have invited your friends. Your routine gets affected and you get tense and tired. Therefore, it is important that you take care of your residential appliance to prevent last minute disasters.

Appliances that you use almost every day are more likely to malfunction. Your refrigerator and washer are two appliances that you use almost every day. When your washer malfunctions, it is best to get help from a washer service technician. This is because your household appliance has several parts that can only be repaired or replaced by a washer technician.

Today, getting a washer repairman to visit your place for washer service or washer repair is easy. All you have to do is give a washer service repair company a call and within no time the washer repair person will be at your place. If you are looking for a good washer repairman near me, all you have do is type “Washer repair near me”, followed by your current residential address, in any search engine. The search engine will display details of all the service providers in your area.

Alternatively, if you plan to repair the washer without professional help, you must identify the parts that are responsible for the problem with your machine. If your washer fills and drains at the same time, here are the parts that could be responsible for the problem.

Water Intel Valve

The inlet valve of your washer is responsible for filling the washtub with hot, warm, or cold water. The working of these valves is controlled by a solenoid which is operated by the electronic control board or the timer. In some washers, the solenoid is also controlled by the pressure or water level switch.

If the water enters the tub during the drain cycle, it could be due to the faulty valve. To check the condition of the valve, disconnect the power supply to the machine when this symptom occurs. If the water continues to enter the tub, it means the inlet valve is defective. On the other hand, if the water stops filling, the problem could be in the switch or electronic circuit board.

Water Level Switch

This switch helps in detecting the correct water level in the washtub. The switch is normally found behind the washer’s control panel. The switch and the tub are usually connected by a dome tube or a hose. When certain water level is reached, the air in the dome tube will push against the diaphragm inside the water level switch. This will turn off the water supply to the tub when the desired water level is reached. If there is a problem with the tube, pressure may not be created to activate the water level switch and water may overflow from the machine.

Before you check the switch, you must check the condition of the dome hose. If it is cracked or worn out, replace it
immediately. At times, the debris inside the dome can prevent the hose from activating the switch. Remove debris from the hose and restart the machine. If your machine does not start even after you have removed the debris or you have replaced the hose, the water level switch may be defective.

You Can Check The Popular Cities We Service Here:

Reno City, Omaha, Albuquerque, Fort Worth, Cleveland, Virginia Beach, Detroit, San Jose, Louisville, Aurora,  Charlotte, Atlanta, San Francisco, Middletown, Seattle, Pittsburgh, San Diego, Austin, Tampa, Dallas, Columbus, Sacramento, Kansas City, Indianapolis, Denver, Nashville, Orlando, Miami, Newark, Little Rock, Tacoma, New York City, Tallahassee, Baltimore, Baton Rouge, Minneapolis, Allentown, Billings, Oklahoma City, Olympia, St. Louis, Colorado Springs, Los Angeles, Jackson, Phoenix, Salt Lake City, Richmond, Silver Spring, Charleston SC, San Antonio, Everett, Tucson, Milwaukee, Philadelphia, Raleigh, Columbia, Las Vegas, Manchester, New Haven, Chicago, Providence, Jacksonville FL, Provo, Henderson, Lakewood, Bowie, Houston Eugene, Birmingham, Boston, Portland

The post How to Fix A Washer That Fills and Drains At The Same Time appeared first on OnSite Appliance